simple layout with no jargon.
Designed for school & community radio.
Nine multi-function channel mixer.
Built in telephone interface.
Built in headphone volume limiter.
Large
,
simple LED volume display.
Remote output for fader starts.
Speaker muting when ‘Mics’ are on.
External mic-light switching output.
‘Programme’ and ‘record’ outputs.
‘Aux’ input for iPod or MP3 players.
Four microphone/line channels.
Four stereo line channels.
Switchable telephone/AUX channel.
Stereo USB audio to and from a PC.
Guest headphone ‘talkback’.
Reliable
,
low cost mixing solution.
Rack or flush mountable.
Integrated AC power supply.
specification
Technical Specification For S0
Mic Inputs Audio Specification
Input Impedance:
> 1k5Ω electronically balanced
Input Gain Range:
Preset pot +24dB to +67dB ref -50dBu
,
TRIM pot ± 15dB
Frequency Response:
40Hz to 20kHz –1dB
,
+0dB
Mic input E.I.N.:
-130dB with 150Ω source
Phantom Power:
+48V to each mic input (SCi selectable)
Displayed Parameters
More than 50 parameters displayed on a wide graphic LCD
Adjustments
From the frontal panel trough OLED/from PC
Number of L-DMOS in amplifier stage
1
RF power stage technology
ICEFET & ECOSAVING
Dimensions: Rack units
2 RU
Dimensions: W – H – D
48.5 – 8.5 – 58.5 cm / 19.11 – 3.35 – 23.05 inches
Weight
9.4 Kg / 20.72 lbs
Number of cooling fans
2
AUDIO PERFORMANCE
MPX input level
+15/-10 dBu for 75 KHz standard deviation
MPX level adjustment
Soft adjust 0.1 dB steps from front panel
MPX input impedance
5 KΩ selectable
L/R input level
+15/-10 dBu for 75 KHz standard deviation
L/R level adjustment
Soft adjust 0.1 dBu steps from front panel
L/R Input Impedance
Selectable 10 K – 600 Ω
,
balanced
AES/EBU input resolution
24 bits
AES/EBU input sample rate
32
,
44.1
,
48
,
96 KHz Automatically selected
AES/EBU input level
-20 dBFS – 0 dBFS
AES/EBU input impedance
110 Ω balanced
AES/EBU-Analog input automatic changeover
Yes
PILOT Amplitude adjustment
Soft adjust 0.05% steps from front panel
PILOT Phase adjustment
Soft adjust 0.01 degree steps from front panel
PILOT tone frequency
19 KHz
PILOT tone deviation
Soft adjust +/- 7.5 KHz
PILOT tone frequency stability
+/- 1 Hz
THD+N (Stereo/Mono operation)
< 0.05% with 75 KHz frequency deviation < 0.05% with 100 KHz frequency deviation 30 Hz to 15 KHz
Pre-emphasis
0/25/50/75 microseconds
,
selectable
Pre-emphasis tolerance
+/- 0.1 dB
FM S/N (MPX operation)
82 dB 20 Hz to 23 KHz @ 53 KHz – detector RMS
FM S/N CCIR (Stereo/Mono operation)
> = 72 dB weighted > = 72 dB unweighted 400 Hz
,
75 KHz frequency deviation
,
quasi-peak detector
,
50 us de-emphasis
Asynchronous AM S/N unweighted
> = 55 dB a 400 Hz
,
75 us de-emphasis
Synchronous AM S/N
> = 50 dB a 400 Hz
,
75 us de-emphasis
Amplitude-frequency characteristic (stereo/mono operation)
+/- 0.1 dB (without pre-emphasis) +/- 0.1 dB (with pre-emphasis) 20 Hz to 15 KHz
,
@ 400 Hz
Stereo Crosstalk (typical)
60 dB @ 400 Hz to 10 KHz
Linear crosstalk
>60 db 20 Hz to 15 KHz
Intermodulation distortion
<0.05% Measured with two of tones 1 KHz & 1.3 KHz
,
ratio 1:1 at 100% modulation
Class of emission
F3
Stereo emission
According to ITU-R reccomendation 450 (pilot tone)
CONNECTORS
RF output connector
N
MPX
BNC Female
LEFT & RIGHT
XLR Female
AES/EBU
XLR Female
AUX
BNC Female
Monitor/19 kHz
BNC Female
RF PERFORMANCE
Output impedance
50 Ω
Automatic power RF control
Stabilizes the output power value on the set value
Overall output power RF stability
+/- 0
,
1 dB
VSWR
2:1 at full power. Automatic power reduction beyond 1.7:1. Transmitter is protected fro open and short circuit.
Harmonics
< -75 dBc
Out of band emission (spurious)
< -80 dBc
EXCITER PERFORMANCE
PLL lock time
<10 sec
Frequency deviation
+/- 75 KHz 0.1 dB steps adjustable
Maximum frequency deviation
+/- 150 KHz
Frequency stability
1 ppm
RF Frequency steps
10 KHz
Phase Response
+/- 0.1 degree from linear phase; 20 KHz to 100 KHz
INSTALLATION REQUIREMENTS
Power supply
110
,
230 Two-Singlephase Version 50-60Hz VAC
Power consumption (typical)
690 W
Overall efficiency (typical from -3 dB to Pnom)
> = 70%
Power factor
> 0.95
Current Consumption @ 230 VAC/single phase
3 A
COOLING/NOISE/DATA
Cooling system
Forced air-cooling
Acoustic noise
< 65 phone @ transmitter room
,
2 M distance from the front of the transmitter
ENVIRONMENT
Temperature range (operating)
-5 ÷ +45 °C
,
23 ÷ 113 °F
Temperature range (non operating)
-20 ÷ +55 °C
,
-4 ÷ 131 °F
Humidity range (operating)
95% @ 40 °C
,
104 °F
Humidity range (non operating)
90% @ 55 °C
,
131 °F
Altitude range (operating)
<3000 meters / <9840 Feet
Altitude range (non operating)
<15000 meters / < 49200 Feet
TELECONTROL & TELEMETRY
Remote control
Yes
Remote control
,
dry contacts
Yes
SNMP option
Yes (external)
features
Features:
High efficiency Extremely low-power consumption and reduced operating costs.
Smart functions/synaptic functions Extraordinary performance level through the use of powerful operational algorithms and inter-module communications within the transmitter. These software algorithms adapt the transmitter to environmental conditions or to any connected device
,
preventing poor RF operation or diminished audio quality.
Very compact size and condensed power Two rack units in height
,
with a weight of less than 14 kilograms (30.8 lbs)
,
unmatched power versus volume and power versus weight ratio.
Planar technology Exceptional stability
,
repeatability
,
reliability and ease of maintenance through the use of planar technology within the entire RF section (RF modules
,
combiners
,
splitter and low-pass filter). This allows for the minimization of internal connections and soldering
,
which increases the long term operation and performance.
Connected everywhere The remote control and management features allow users to receive data and send instructions to the transmitter via several state-of-the-art communication channels — SMS
Sonifex AVN-TB20AR
In stock
$ 4,207.25Original price was: $ 4,207.25.$ 4,019.48Current price is: $ 4,019.48.