The Sonifex RB-MA1 consists of a low noise microphone pre-amplifier for converting mic level signals to line level, or for driving long lines from microphones to mixing equipment.
Sonifex RB-MA1 Original price was: €480.00.Current price is: €455.00.
Back to products
The Sonifex RB-MA2G consists of two independent low-noise microphone pre-amplifiers with front panel level controls and metering, for converting microphone level signals to line level, or for driving long lines from microphones to mixing equipment.
Sonifex RB-MA2G Original price was: €650.00.Current price is: €615.00.

Sonifex RB-MA2

The Sonifex RB-MA2 consists of two independent low-noise microphone pre-amplifiers for converting mic level signals to line level, or for driving long lines from microphones to processing equipment.

 

 

Original price was: €510.00.Current price is: €485.00.

SKU: 105646 Brand:Sonifex

The Sonifex RB-MA2 consists of two independent low-noise microphone pre-amplifiers for converting mic level signals to line level, or for driving long lines from microphones to processing equipment.

All connections and controls are on the rear panel. The microphone inputs are XLR-3 type and are electronically balanced. The input gain for each input can be adjusted individually by a recessed pre-set potentiometer, which allows for the use of both dynamic and powered microphones.

The XLR-3 line outputs are electronically balanced and can be wired unbalanced by grounding the non-phase signal, allowing you to feed both balanced and unbalanced equipment.

For each channel, there are independent switches to control a high pass filter (low frequency roll-off at 125Hz) and to provide phantom power at +48V to the connected microphones.

RB-MA2 Diagram

RB-MA2 Block Diagram.

Technical Specification For RB-MA2

Audio Specification

Maximum Input Level:-10dBu
Maximum Output Level:+28dBu
Low Frequency Roll-Off:125Hz @ 6dB/octave
E.I.N.:130dB
Common Mode Rejection:>60dB typically
Frequency Response:20Hz to 20kHz ±0.1dB (600 Ω load, ref 1kHz)
Input Impedance:2 kΩ nominal balanced
Output Impedance:<50 Ω
Gain Range:Adjustable 36dB to 75dB gain (each input)
Distortion:0.01% THD @ 1kHz, ref +8dBu output
Phantom Power:48V

Connections

Input:2 x XLR 3 pin female (Balanced)
Output:2 x XLR 3 pin male (Balanced, can be unbalanced)
Mains Input:Filtered IEC, switchable 110-120V, or 220-240V, fused, 6W max
Fuse Rating:Anti-surge fuse 100mA 20 × 5 mm (230VAC)
Anti-surge fuse 250mA 20 × 5 mm (115VAC)

Equipment Type

RB-MA2:Dual microphone amplifier

Physical Specification

Dimensions (Raw):28 cm (W) x 10.8 cm (D) x 4.2 cm (H) (1U)
11” (W) x 4.3” (D) x 1.7” (H) (1U)
Dimensions (Boxed):36 cm (W) x 20.5 cm (D) x 6 cm (H)
14.2” (W) x 8” (D) x 2.4” (H)
Weight:Nett: 1.00 kg Gross: 1.45 kg
Nett: 2.2lbs Gross: 3.2lbs

Reviews

There are no reviews yet

Add a review
You must be logged in to post a review Log In