sonifex rb sm2 1

The Sonifex RB-SM2 is a dual version of the RB-SM1, consisting of two independent converters which will produce two fully buffered and balanced mono line outputs from two stereo inputs.

All connections are on the rear panel. The XLR-3 inputs are electronically balanced with an impedance of 20kΩ bridging. These can be wired unbalanced to accept an output from domestic equipment.

The XLR-3 line outputs are electronically balanced with an output impedance of <50Ω. The outputs can be wired unbalanced by grounding the non-phase signal, allowing you to feed both balanced and unbalanced equipment.

Output gain adjustment using pre-set potentiometers for both converters allows a normalised mono output from domestic stereo equipment. The potentiometers are accessible through the rear panel.

RB-SM2 Diagram

Audio Specification

Maximum Input Level:+28dBu
Maximum Output Level:+28dBu
Input Impedance:>20kΩ balanced bridging
Output Impedance:<50Ω balanced
Frequency Response:20Hz to 20kHz ±0.1dB (600Ω load, ref 1kHz)
Gain Range:Adjust -8dB to +18dB gain, ref. 0dB input on L and R
Common Mode Rejection:>66dB typically
Distortion:0.01% THD @ 1kHz, ref +8dBu output
Noise:-100dB, unity gain, ref +8dBu output

Connections

Inputs:4 x XLR 3 pin female (Balanced, can be unbalanced)
Outputs:2 x XLR 3 pin male (Balanced, can be unbalanced)
Mains Input:Filtered IEC, switchable 110-120V, or 220-240V, fused, 6W max
Fuse Rating:Anti-surge fuse 100mA 20 x 5mm (230VAC) Anti-surge fuse 250mA 20 x 5mm (115VAC)

Equipment Type

RB-SM2:Dual stereo to mono converter

Physical Specification

Dimensions (Raw):28cm (W) x 10.8cm (D) x 4.2cm (H) (1U) 11” (W) x 4.3” (D) x 1.7” (H) (1U)
Dimensions (Boxed):36cm (W) x 20.5cm (D) x 6cm (H) 14.2” (W) x 8” (D) x 2.4” (H)
Weight:Nett: 1.05kg Gross: 1.50kg Nett: 2.3lbs  Gross: 3.3lbs
BW Price Guarantee

(Subject to conditions)

Sonifex RB-SM2

$433.00

Tech Support

2-Year Warranty

$433.00

Related products
STUDIO Sonifex RB-SM2