DR HYBRID-2

D&R HYBRID-2

The DR HYBRID-2 is the active version of the well known passive Hybrid-1 model.

Its concept originates from many demands for a more sophisticated hybrid with more features.

The unit is an analogue unit with digital control and features like ducking, making intelligibility a lot better in the broadcast.

Telephone hybrids provide the interface between professional audio equipment and the public telephone network. They provide protection for your equipment and the public telephone lines, allowing for varying line signals and line conditions.

Automatically cancelling out the unwanted signal, they also facilitate two-way communication down a single telephone line.

Each DR HYBRID-2 has a telephone line connection, a handset connection, and separate connectors for audio input and output from a broadcast mixer, or other professional audio sources.

The front panel of DR HYBRID-2

CONNECT BUTTON (RING):

Line connect the switch to connect and disconnect calls from the telephone line. It can be remotely driven by connecting a switch to the GPIO sub D connector.

LC:

Variable Low Cut filter to filter out unwanted low frequency noise.

HC:

Variable High Cut filter to filter out unwanted high frequency noise.

Rear panel

POWER:

The unit is powered by a removable IEC-type power cord.

An internal switched power supply is built in to accept voltages between 90V – 245V

LINE:

RJ-12 connector to connect with the public telephone network.

PHONE:

RJ-12 connector to connect with a handset.

C-BALANCE:

8 pole mini-dip switch to select the optimum side tone attenuation

R-BALANCE:

Internal potentiometer to adjust for optimum side tone attenuation.

GPI:

Jack connector for remote control.

AUDIO + GPIO:

A combination of audio in/outputs and logic for D&R and other broadcast mixers.

RECEIVE:

Male XLR to be connected to the input of the mixer.

SEND:

Female XLR input to be connected to Mix-Minus/Clean feed (N-1)output of the mixer. DR HYBRID-2

  • Active balanced interfacing.
  • Variable High and low cut filters.
  • Industry-standard connectors
  • Superb audio separation.
  • Externally adjustable R and C balance.
  • Remote controllable.
  • GPIO interfacing with mixing consoles.
SEND Impedance 10k Ohm, electronically balanced Common mode rejection >40dB Maximum input level +26dBu Nominal input level +4 dBu Frequency response 20Hz – 15kHz (-3dB variable via HC and LC filters) Connectors XLR type 3 pin female Gain range receive control 40dB RECEIVE Impedance < 50 Ohm, electronically balanced Common mode rejection >40dB Maximum output level +26dBu Nominal output level +4 dBu Bandwidth to telephone line 250Hz – 4kHz, -3dB ref 1 kHz Telephone line impedance Nominally 600 ohm Telephone line impedance range 300 ohms to 1500 ohms Connectors XLR type 3 pin male Gain range send control +6dB to –20dB

SPECIFICATIONS

Output: balanced line level

Input: Line level 0 balanced

R/C balance: fully adjustable

Separation: More than 35 dB

DIMENSIONS

1 HE front panel: 482×44 mm

Shipping Dimensions:53×23×10 cm

Weight 3.5 kg incl. packing

EAN CODE: 7436917139169

BW Price Guarantee

(Subject to conditions)

D&R HYBRID-2

$452.00

Tech Support

2-Year Warranty

$452.00

Related products
STUDIO D&R HYBRID-2