Showing all 13 results

Belar LP-1A

In stock

Original price was: €720.Current price is: €685.
Product can be split into multiple boxes

0

Ship Separately

0

specification

Model LP-1 Shielded Loop Antenna

Frequency Range
530 kHz to 1610 kHz in 3 bands

Diameter
33"

Mounting
1/2" NPT

Connector
BNC

Attenuation
30 dB

Permissible Wind Load
150 mph

,

100 mph with 3/4" ice

Belar AMMA-2

In stock

Original price was: €3,745.Current price is: €3,565.
Weight 4.5 kg
Product can be split into multiple boxes

0

Ship Separately

0

specification

Specifications:

RF Frequency Range
150 kHz to 30 MHz

RF Tuning Increments
1 kHz

RF Sensitivity
1 to 10 volts rms

RF Input Impedance
500 ohm or 50 ohm

,

internally connected

Accuracy
1.0%

Display Large
Large 3 digit LED for Negative Modulation

,

16-character alphanumeric LED display for menus and parameters

Frequency Response
±0.1 dB

,

30 Hz to 10.2 kHz

-3dB @ 11.9kHz

-100 dB @ 16 kHz

Audio Outputs

Audio Monitor
+10 dBm

,

600 ohm

,

balanced (XLR)

,

NRSC or Flat

Audio Test
2.5 V rms unbalanced (BNC)

Frequency Response
±0.1 dB

,

30 Hz to 10.2 kHz

Distortion
less than or equal to 0.1% @ 99% modulation

IMD (SMPTE

,

CCIF

,

DIM)
less than or equal to 0.1% @ 99% modulation

Signal to noise ratio
75 dB

Signal Delay
Test: 3 ms.

,

Meter: 90 ms.

Automatic Carrier Level Adjustment range
25-150%

Remote Meter Output
Jack for optional MP-17 analog remote meter panel

Remote Alarms
Relays for Loss of Modulation

Normal

,

Negative PPM

,

Positive PPM

Loss of Carrier

,

Remote

,

and General alarms.

Relays can be set NO or NC

Serial Interface
RS-232/RS-422

Unit Interface
Wizard Standard Interface

Power Requirements
20 watts

,

100-240 Vac 50/60 Hz

Dimensions
1 3/4"H x 14"D x 19"W (EIA rack mount)

Shipping Weight
10 lbs (4.5 kg)

features

MEASUREMENTS:

Positive Peak Modulation in Percent
Negative Peak Modulation in Percent
Positive Peaks-per-Minute Count
Negative Peaks-per-Minute Count
Positive Peak Average & Peak Min Modulation
Negative Peak Average & Peak Min Modulation
Positive Average/Peak Modulation Ratio
Negative Average/Peak Modulation Ratio
Normal Modulation Peaks-per-Minute Count
AM Noise rms detected in dB
Carrier Level
Carrier Reference
Carrier High in sliding 1 minute window
Carrier Low in sliding 1 minute window
Carrier Ratio High/Low in dB

 
SETTABLE PARAMETERS:

Positive & Negative Peak Modulation Indicator
Positive & Negative Peaks/Minute Indicator
Normal Modulation Indicator
Positive & Negative Peaks/Minute Duration
Audio Failure Alarm – Time & Modulation
Modulation Mode (Normal/Fixed/MDCL/IMOD)
MDCL Reference
Carrier Shift Alarm
Carrier Failure Alarm – Time & Level
Display Hold Time
Time Mode (Real/Past)
Infinite Hold
Audio Outputs (Test/Meter)
Modulation Calibrator
Tuning Frequency
Tuning Mode (Dir/Auto/Scan/Lock)
Tuning Frequency Increments

Belar FMMA-1

In stock

Original price was: €4,315.Current price is: €4,115.
Weight 5.4431 kg
features

MEASUREMENTS:

Total Peak Modulation in Percent
Peak Modulation expressed in kHz Deviation
Peaks-per-Minute Count
Loop-thru #1 Modulation
Loop-thru #2 Modulation
Peak Average Modulation
Average/Peak Modulation Ratio
Peak Minimum Modulation
AM Noise (with Option 02)
Synchronous AM Noise (with Option 02)
RF Level (with Option 02)
Pilot Modulation (requires FMS-2 or other source of filtered pilot)
Pilot Injection (requires FMS-2 or other source of filtered pilot)
SCA Injection (requires SCM-2 or other source of filtered SCA)

 
SETTABLE PARAMETERS:

Hold Time
Peak Modulation Indicator
Peaks-per-Minute Indicator
Display Hold
Display Blanking
Peaks-per-Minute Duration
Remote Enable
Audio Failure Alarm – Time & Modulation
Loop-thru #1 Gain (+20% Modulation)
Loop-thru #2 Gain (+20% Modulation)
Display Resolution (01% or 1%)
Time Mode (Real/Past)
Peak Weighting (8 time constants)
Calibrator (with Option 01)

specification

SPECIFICATIONS:

Accuracy:
0.1%

Display:
Large 4 digit LED for Total Modulation

,

16 segment alphanumeric LED display for menus and parameters

Input:
Composite or 650 Khz IF (with Option 01) for use with

Belar RFA-4

,

RFA-1A

,

or DC-4

,

or RF transmitter sample (with Option 01 and Option 02)

Option 01:
Precision FM Demodulator with Calibrator

Input:
650 kHz IF (From RFA-4

,

RFA-1A

,

DC-4

,

or Option 02)

Output:
Two 75 ohm buffered

,

composite

Signal/Noise:
> 95dB

Distortion (IM):
< 0.003%

Distortion (THD):
Unmeasureable (< 0.01%)

Option 02:
Down Converter and Synchronous AM Noise Detector

Frequency Range:
88 to 108 MHz Std. (Specify frequency)

Input:
1-10 volts rms

,

50 ohms

,

BNC connector

Outputs:
650 kHz IF

,

9-pin D connector to Wizard

Signal/Noise:
> 95 dB

AM Noise Range:
-17 to -80 dB

Synchronous AM Noise Range:
-17 to -80 dB

Ship Separately

0

Product can be split into multiple boxes

0

Belar FMHD-1

In stock

Original price was: €7,585.Current price is: €7,225.
Weight 6.8039 kg
features

Frequency Agile Antenna and High Level Inputs
RF Spectrum Analysis with Mask and Sideband Power Measurements
Metering of Analog Total

,

Pilot

,

L

,

R

,

L+R

,

and L−R
Metering of HD L

,

R

,

L+R

,

L−R Audio
Time Alignment Graphic Display Analysis ±16384 samples

,

±375 ms to ±256 samples

,

±5.8 ms Audio Polarity
Level Alignment Graphic Display Analysis ±20.0 dB
HD Control and Status Information
HD SIS and PAD Data
BER (Bit Error Rate) Measurements

specification

RF Inputs

Antenna Input
87.5 to 108 MHz Frequency Agile

75 Ω

,

F Connector

RF Inputs
87.5 to 108 MHz Frequency Agile

1 to 10 Vms

,

50Ω

,

BNC Connector

Composite Outputs

Analog (2)
+1.5 Vms@100%

,

75Ω Unbalanced

BNC Connector

Digital (2)
LVDS

,

100Ω

,

RJ-45

Audio Outputs

Analog (8 Channel Assignable)
+10 dBm

600Ω Balanced

,

XLR Connector

AES-3ID (6 Channel Assignable)
1.0 Vp-p

75 Ω

,

BNC Connector

Headphone (L/R Assignable)
1/4” Phone Jack

Computer Interface

RS-232
9 pin Male D Sub Connector

Ethernet 10/100 Base-T
RJ-45 Connection

Alarms

Relays(4 Assignable)
Form C

,

15 pin Female D Connector

Dimensions
2 EIA Rack Unit

Power Requirements
40 Watts

,

100-240V

,

50/60 Hz

Shipping Weight
15 lbs

Ship Separately

0

Product can be split into multiple boxes

0

Belar AMM-4

In stock

Original price was: €2,305.Current price is: €2,195.

Belar FMHD-1L

In stock

Original price was: €4,795.Current price is: €4,565.

Belar FMM-4A

In stock

Original price was: €2,585.Current price is: €2,455.

Belar AMDA-1

In stock

Original price was: €1,145.Current price is: €1,085.

Belar FMM-2

In stock

Original price was: €3,435.Current price is: €3,275.

Belar SCMA-1

In stock

Original price was: €3,825.Current price is: €3,435.

Belar FMCS-1L

In stock

Original price was: €4,605.Current price is: €4,385.
Weight 6.8 kg
Product can be split into multiple boxes

0

Ship Separately

0

specification

Metering

Modulation (Peak

,

Ave

,

Min)

Total

,

L

,

R

,

L+R

,

L!R
0 to 150%

,

0.1% resolution

Pilot
0 to 15.0%

,

0.1% resolution

RMS

Total

,

L

,

R

,

L+R

,

L!R
+3.0 to !120.0 dB

,

0.1 dB resolution

Flat & 50 µs or 75 µs

AM Noise

,

Sync AM Noise
0.0 to -100.0 dB

,

0.1 dB resolution

Separation
0.0 to !120.0 dB

,

0.1 dB

Crosstalk
0.0 to !120.0 dB

,

0.1 dB resolution

Composite Outputs

Analog (2 buffered)
1.5 Vrms @ 100%

,

75Ω unbalanced

BNC Connector

Digital (2 buffered)
LVDS

,

100Ω

,

RJ-45 Connector

Audio Outputs

Analog Outputs (6 assignable)
+10 dBm

,

600Ω balanced

XLR Connector

Analog Outputs (2 assignable)
5 Vrms

,

75Ω unbalanced

BNC Connector

AES-3ID (8 assignable)
1.0 Vpk-pk

,

75Ω

,

BNC Connector

Headphone (assignable)
1/4" Phone Jack

Alarm Outputs

Relays (4 assignable)
FORM C

,

15-pin Female D-Sub Connector

Computer Interface

USB
Port

Ethernet 10/100 Base -T
RJ-45 Jack

Dimensions
19"x3.5"x14.5"

,

2 EIA Rack Units

Power Requirements
40 Watts

,

100-240V

50/60 Hz

Shipping Weight
15 lbs (6.8 kg)

features

Frequency Agile RF input
AM & Sync AM Noise measurements
HD RF carrier rejections filters to improve analog readings in the presence of HD carriers.
FM Demodulation with 100 dB 75 µsec SNR
Variable Bandwidth Composite Filtering
Stereo Demodulation with 100 dB L/R Separations
Full metering of Analog Peak and RMS values
RDS Injection/Phase and Full Data decoding
Two SCA Decoders
RF

,

Composite

,

and Audio FFT Spectrum Analysis
RJ-45 Ethernet Interface with remote PC software

Belar FMSA-1

In stock

Original price was: €4,785.Current price is: €4,555.

Belar FMS-2

In stock

Original price was: €4,785.Current price is: €4,555.